Ultrafloor
e-straight joint
e-straight joint
The e-straight construction joint is our new solution for concrete industrial floors with less static (racks) and dynamic (traffic) load requirements.
The appropriate choice for a construction joint is always a function of engineering and calculations for load transfer. Please chose whether you want to run a pre-calculation yourself with our online tool or if you want us to provide you with a complete and free-of-charge design check.
Why e-straight?
The e-straight joint is an efficient solution for non-traffic areas where the sliding effect is not needed. The e-straight construction joint is based on the e-slide technology and differs only with the straight upper steel plates. The Omega load transfer system and the 3D anchorage system is similar to the e-slide and in combination with the e-slide it can control dynamic and static load challenges. It can do this in a more economical way for floors with lower load and traffic demands.
Advantages:
Continuous 3D anchorage system (patented technology)
High level of comfort experienced by forklift operators
Free horizontal movement of the floor in 2 directions
Straight edge protection
Technical data
